< Back
  

The picture shows the control unit with the single 'GO' push button

  
 Garden use  Automatic watering system
 Toilet cisten filling  Save in a water butt or barrel and use for toilet flushing
 DIY installation  Do It Yourself - easy to install using simple household tools
 Safety  Audible alarms for scalding, freezing, hot water used up
 Low Cost  Affordable by all
 Programmable  For silent operation, preferred temperature plus many more . . . . .
HS200UN Universal battery powered water saver  
We are offering a discount of 10 % for 1 off and 15% for 2-5 off, for the next 20 new customers

Powered by a single household PP3 9V battery and for use with 15mm water pipes.

Especially important for homes with water meters and boats carrying their own water. Applicable for bath and shower rooms.

Located for easy access with manual activation and automatic stop, this product is principally for use to save clean, cold water that is usually drained away while waiting for hot water to arrive at a hot tap. It comes complete with:- isolating pipe attachment, temperature sensor, water valve and hose / push in pipe connections.

 

! ! ! PLEASE ENSURE THAT YOU HAVE 15mm COPPER WATER PIPES BEFORE ORDERING ! ! !

 

 

 

 

This product comes as a kit, complete with the following:-

Control unit - electronic, household PP3 battery powered (battery available as an option, not supplied)
Cable - white, 4 metres
Isolating tap  - containes double check valves (self cutting as connection into existing hot tap water pipe)
Water pipe  - 0.5 metre flexible (connects isolating tap to water valve)
Water valve  - small, with pipe clip mounting
Temperature sensor  - attached to junction box (is clipped around the hot water pipe)
Garden hose connector - 1/2" for saved water output
Push in pipe fitting - to connect to normal 15mm diameter plumbing as alternative method for saved water output

 

If you want to know more technical information go to the Product Selection page and select model reference HS200UN.



Was    Is      Add to basketBasket

  
Also check out these products:
  
 
 

 

SYSTEM PIPE CONNECTION INFORMATION

 

This picture shows how the various component parts are connected together. The hot water normally flows up the copper pipe, at the bottom of the picture, towards and out of the tap at the top. When the operator presses the button on the Hydrosave contol unit, the water valve is opened allowing the water to flow up the copper pipe, past the black temperature sensor/junction box to the isolating tap (black top and connected into the copper pipe). The water then passes down through the grey flexible pipe, through the water valve (clamped onto the copper pipe) and out to the storage barrel/butt or to the point of use through the (yellow) garden hose or a pipe push-in fitting (black unit shown to the side). When the temperature sensor detects hot water, the water valve is shut and the water saving operation is complete.
 

 

AIR OPERATION  - OPTION HS200UN/AB

The very robust air operating button, housed in a metal box for wall mounting, is connected through the air pipe to an air operated electrical switch. This assembly can be purchased as an option and will be delivered with the electrical switch mounted inside the Hydrosave control unit (not shown), ready for installation. This provides a completely voltage free operation for situations where there is a lot of splash water.

 

 

ShopFactory (TM). Click Here.